![]() Vehicle Event - Notification sent when asset turns the Ignition On, Ignition Off, Vehicle Towed, Low Battery Voltage, Portable Low Battery, Hard Braking, High G-Force Event, Main Power Applied, Main Power Removed, Rapid Acceleration, or Harsh Turn. Temperature - Notification sent if the temperature of the box gets too warm or cold for a defined number of minutes. SP Speeding - Notification sent when an asset is traveling greater than the posted speed limit for a duration of time. These users within the alert will be able to configure the Speed at which this alert will trigger (5 MPH minimum) as well as the duration at which an alert will be retriggered after an asset stops and then moves again without a seatb elt being utilized ( 5 minutes m inimum). Seatbelt Monitoring - A real-time notification when their operators are operating an asset without wearing a seatbelt. ![]() No Movement Alert - Notification sent when the asset reports no movement during a specific time threshold. Landmark - Notification sent when a asset arrives or departs a landmark or landmark category. I/O Use - A notification that the I/O has been engaged for more than a defined threshold, engaged while in motion, or engaged outside the designated landmarks. I/O Event - Notification sent when a specified I/O is turned On and Off. High Limit Speed - Notification sent upon an asset exceeding the speed of the threshold set. Geofence - Notification sent when an asset enters, exits, or drives within a selected Geofence. This allows the user to respond back to the operator. Garmin Message - Notification that an asset has sent a message. This alert can be set for Stops at Landmarks or Non-Landmarks only.įirst Movement - Notification sent when the asset reports its first movement of a calendar day. If the asset has a PTO (Power Take Off), the alert can be set to break idle when it is in use.Įxtended Stop - Notification sent when an asset is stopped for a duration that is greater than the stop threshold set. ![]() The alert can be configured for a "specific" DTC code (Diagnostic Trouble Code) or "all" codes that were triggered along with a clear description of the issue.Įngine Idle - Notification sent if the asset is idling for a greater time than the defined threshold. Events can be viewed as videos to help coach operators on driver safety.Īny Movement - Notification sent when the asset reports any movement every four hours within the selected date and time.Įngine Diagnostics - Notification sent when a Check Engine Light comes on. Please read below to see the description of the Alerts that IntelliShift offers.ĪI Video Event- Notification sent when the asset reports a Distracted Driver, Driver Smoking, Forward Collison Warning, Harsh Left Turn, Harsh Right Turn, Lane Departure Warning, Low Voltage, Over High Speed, Pedestrian Collison Warning, Rapid Acceleration, Video Loss, Driver Fatigue, Following Distance Warning, Hard Braking, Lens Covered, No Driver Detected, Panic Alarm, Phone Utilization, or Unbuckled Seatbelt. ![]() Alerts provide the ability to receive real-time notifications when certain events are triggered within the IntelliShift platform. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |